** WAR's "Black Tank" Tumbler Build **

WAR Machine · Post by **WAR Machine** » Wed Oct 09, 2024 2:42 am

* Update...

Managed to get the side and front sections together...
Just used some scrap wood to support it on the sides even thou I did do the 2inch tape and glue again...

And then left it to set and the next morning I ran over the join lines again with some more glue and left again to set...

slysnake · Post by **slysnake** » Wed Oct 09, 2024 11:58 am

Sorry, I'm not super familiar with this car. What is the function of this piece?

WAR Machine · Post by **WAR Machine** » Fri Oct 11, 2024 3:38 am

slysnake wrote: ↑Wed Oct 09, 2024 11:58 am Sorry, I'm not super familiar with this car. What is the function of this piece?

Hey Sly,
This is the front nose cone section that sits between the front wheels...

slysnake · Post by **slysnake** » Fri Oct 11, 2024 9:06 am

Ah! OK.

WAR Machine · Post by **WAR Machine** » Wed Nov 27, 2024 9:20 am

Small Update...

Once set I did another layer of glue along all the joins and let it set, flipped it around and did the same on the outer edges after removing the 2inch tape.

Did a quick layer of resin to pull into the wood to seal it before the fiberglass gets applied...

slysnake · Post by **slysnake** » Sun Dec 01, 2024 11:20 am

Looks very nice!

lilboatsman · Post by **lilboatsman** » Sat Dec 07, 2024 6:09 am

Great work!

The 1989 Batmobile Forum

WAR's "Black Tank" Tumbler Build

Re: WAR's "Black Tank" Tumbler Build

Re: WAR's "Black Tank" Tumbler Build

Re: WAR's "Black Tank" Tumbler Build

Re: WAR's "Black Tank" Tumbler Build

Re: WAR's "Black Tank" Tumbler Build

Re: WAR's "Black Tank" Tumbler Build

Re: WAR's "Black Tank" Tumbler Build